How to make a papasan chair cushion?
Making a papasan chair cushion can be a fun and rewarding DIY project. Here’s a step-by-step guide to help you create a comfortable and stylish cushion for your papasan chair:
Materials Needed:
  • Fabric (about 4-6 yards, depending on the size of your papasan chair and the width of the fabric)
  • High-density foam or batting (thick enough to provide adequate cushioning)
  • Scissors
  • Sewing machine
  • Thread
  • Pins
  • Measuring tape
  • Fabric chalk or a fabric marker
  • Zipper or buttons (optional, for a removable cover)

Steps:
1. Measure the Chair
Measure the diameter of your papasan chair. Most papasan chairs have a diameter of around 45-48 inches, but it’s essential to get an accurate measurement for a perfect fit.
2. Cut the Fabric
  • Fold the fabric in half and mark a semicircle using your fabric chalk or marker. The radius of the semicircle should be half of the chair's diameter plus an additional 2 inches for seam allowance and extra fluffiness.
  • Cut out the semicircle. You should have a large circle when you unfold the fabric.
  • Repeat this step so you have two large fabric circles.

3. Prepare the Cushion Filling
  • Cut the foam or batting into circles slightly smaller than your fabric circles. You can layer the batting to achieve the desired thickness. If using foam, consider using a high-density foam for better support and longevity.

4. Sew the Cushion Cover
  • Place the two fabric circles together with the right sides facing each other.
  • Pin the edges together, leaving a gap of about 18 inches for inserting the foam or batting.
  • Sew around the edges of the circles with a 1-inch seam allowance, except for the gap you left.
  • Turn the fabric right side out through the gap.

5. Insert the Cushion Filling
  • Stuff the fabric cover with the foam or layers of batting through the gap. Make sure the filling is evenly distributed.
  • Once the filling is inside, hand-sew the gap closed using a slip stitch for a clean finish. If you opted for a removable cover, sew a zipper or buttons along the gap before inserting the filling.

See the next steps at: https://thanhcongcraft.com/how-to-ma...cushion-cover/